A .jar file is just a glorified .zip file.  You can inspect its contents and see whether the ‘setup.lisp’ file actually were there.

MA

> On Aug 18, 2015, at 13:42 , Hamda Binte Ajmal <hamda.binte.ajmal@gmail.com> wrote:
>
> Yes,
> I placed the setup.lisp inside a folder inside the src folder, so I am assuming it is transferred to jar after building the project.
> Yes, of course I substituted the paths!
>
> On Tue, Aug 18, 2015 at 11:38 AM, Pascal J. Bourguignon <pjb@informatimago.com> wrote:
>
>> On 18 Aug 2015, at 11:45, Hamda Binte Ajmal <hamda.binte.ajmal@gmail.com> wrote:
>>
>> Hi,
>> I am sending this message again, as the last thread went a little too far.
>> I have developed a Java Application that runs lisp code at the back end, and I use ABCL for that.
>> Before using the lisp commands, I load a few .lisp files so that I can call the functions defined in those files.
>> Everything works fine as long as I run the application from Netbeans.
>> When I run the application from the jar file, it throws 'File not found error'.
>> as the lisp files are not a part of file system inside the project jar.
>> I tried to follow the suggestions given by Mark
>> (load “jar:file:/absolute/path/to/file.jar!/path/within/jar/setup.lisp”)
>> It shows the same File not found error. Am i missing something here?
>
> Well,
> 1- did you include setup.lisp in the jar file?
> 2- did you substitute the paths in the suggestion given by Mark?
>
>
> --
> __Pascal J. Bourguignon__
>
>
>
>
>
>
> --
> Hamda Binte Ajmal
> +92 344 550 7680

--
Marco Antoniotti